Have you ever imagined that a vape device can serve as both a pod mod and a regular mod? Now the R80 makes it possible. Featuring the single 18650 cell with 80W max output and 0.96’’ display with changeable colors, R80 comes beyond your imagination. Moreover, the replaceable coils with adjustable airflow system will be another major attraction of R80. Faster charging, visible large capacity, humanized cover open way, R80 will be your priority whatever in appearance or function.
Size: 116.2 x 32 x 31.5mm
Cell type: high-rate 18650 cell (discharging current should be above 25A)
E-liquid capacity: 4ml
Resistance: 0.3ohm Mesh and 0.8ohm Nicr Coils
Maximum charging current: 2A
Maximum output wattage: 80W
Colors: classic legend, meteor shower, northern lights, ocean star, quantum world
Single 18650 Pod Mod with 80W Max Output
User-friendly Battery Cover Open Way
0.96inch TFT Screen with Changeable Colors
Replaceable Coils with Adjustable Airflow System
4ml Large Refillable Cartridge with Visible Capacity
Compatible with both Cartridges and Tanks
Brand-new USB-C Port for Faster Charging
1 x R80 (without cell)
1 x R80 Cartridge (WV-M 0.3ohm Coil Pre-installed)
1 x WV01 Single 0.8ohm Coil
1 x USB-C Cable
1 x User Manual
1 x Warranty Card
2 x Warning Card
Was so eager to try this R80 cause I have always loved your products and have been getting into pods lately.
Let me start off by saying its an amazing concept. I love that I can use a dust capped pod at work and then switch over to the 510 and use my sub ohm tank. Very innovative and the design is awesome, looks great.
Unfortunately you guys put the fill port at the bottom of the pod. Not a good idea as liquid does seep through the rubber gasket slightly.
Also big con is the coil leaks very badly getting the connection/ magnet area full of E juice as well. Very disappointing and also very dangerous for the use of the external 18650 battery.
The coils are leaking through the adjustable air flow portion of them if it sits for more than a few hours.
Suggestion is definitely put the fill port at the top and also design a way for the press fit coils to not leak perhaps by removing the airflow adjustment on the coil.
Hope this helps as I want to see and purchase more great products from you in the future!